Mazda RX-7 Mini-Kit Angle (FC)

We are proud to announce our angle solution for the second generation Mazda RX-7. 

This is a 100% bolt on solution*. Made from high quality billet 7075, then anodized for long lasting protection, assembled with top quality bearings & rod ends and machined CAD plated ball-joint studs. All built in the USA. 

Full installation instructions here: SLRspeed FC3S Mazda RX7 Mini-Kit Angle Kit Instructions

This lock kit features: 

• Bolt-on* double sheer control arm extensions to increase track width 50mm oer side (+100mm  overall) for wheel and tire clearance 
• Allows for up to 60° of steering angle, wheel/tire size & offset dependent 
• High quality impact resistant tie-rod ends
• 40% quicker steering ratio over factory
• Quick four position Ackerman adjustment allows you to tune your setup for each track and driving style. 
• 35mm of roll-center correction improves front end geometry on lowered cars 
• Bump steer corrected outer tie rod end with billet aluminum tie rod extension tubes, allows use of factory style inners.
• All hardware included for quick and simple bolt-on installation. 

Compatibility: Will require use of the Series 4 (S4) '85-'88 front control arms. They use a bolt-on front ball-joint which this replaces.

*Power Steering Rack only

- MANUFACTURED AND ASSEMBLED IN USA 🇺🇸 -